![]() ![]() #Nexstar cx driver download fullIt’s got a nice set of graphics on the front with some key features, and a full list of features and specifications on the back. The packaging for the NexStar CX is rather nice, yet standard. SATA III support would definitely be necessary to come close to the 5Gbps estimated speed. On a final note, this enclosure only support up to SATA II which means at most you can expect 3Gbps. When larger drives become available, baring any huge changes to how drives work, larger capacities will/should work. Also take note, the 2TB maximum is based on currently available capacities. An external Iomega IDE USB drive does show up and works fine. Note the Hot-Swappable feature and keep in mind that this isn’t anything new. The old WD IDE drive in the USB NexStar enclosure does not show up in Disk Management. Here you can see Vantec flaunting some nice USB 3.0 specs such as the previously mentioned 5 Gbps transfer rate of USB 3.0. For USB 3.0 Speeds, the System Must Support USB 3.0 Specifications (CD-Rom Drive May Be Needed For Drivers).I will test using some off the shelf benchmark software, as well as moving several files of varying sizes and checking the speed using Window’s transfer speed display.īut first, a Closer Look at the NexStar CX. So, now that I have you interested, lets see how fast USB 3.0 actually is. Vantec NexStar CX USB 3.0 External drive enclosure While that is the theoretical maximum, the spec does see 3.2 Gbps to be achievable. This enclosure is for a 3.5″ SATA drive and transfer data at a wopping 5Gbps! Yes, that’s more than 10 times faster than USB 2.0’s 480Mbps. That brings us to today, where our friends at Vantec have joyously given us a wonderfully fast USB 3.0 external drive enclosure, the NexStar CX. January 2010 comes around and we finally start to see motherboards that can actually use USB 3.0, but sadly few devices to use it with. The completed spec for USB 3.0 was introduced to the masses in 2008 along with it’s SuperSpeed namesake, and since then we’ve been waiting for USB 3.0 devices to make our Hi-Speed USB 2.0 devices feel inadequate. Is there any way to disable this power management "feature"? I wasn't able to find any instructions from the manufacturer of the enclosure.USB 3.0: Faster than fast, but not too fast I used to have a Vantec NexStar CX enclosure for the same type of HDD, which I also connected to the same laptop via eSATA and it did not have this behavior. ![]() ![]() #Nexstar cx driver download seriesI searched online for similar issues, and even though I have the Intel(R) 5 Series 6 Port SATA AHCI Controller, disabling the HIPM / DIPM (AHCI Link Power Management) features does not change anything. #Nexstar cx driver download PcOne of the drives is a 1TB SATA Western Digital HDD (WD1001FALS-00E3A0).īecause I also tested it with a 500GB drive as well as on a different PC and it had the same behaviour, I will blame it on the enclosure itself. The problem is that it takes around one minute for it to be powered back up, which completely confuses the operating system (Windows 7 圆4) and causes all sorts of errors. I bought a new Delock 3.5″ External Enclosure SATA HDD to USB 2.0 / eSATA for some backup SATA HDD drives that I keep around and everything works just fine, except that if I leave the drive to idle for 5 minutes (precisely 5 minutes), it gets powered down. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |